A range of units to add on to our existing
range of power sources to convert them to TIG units. Some
of these units have slope up and down digital display
and torch latching.
ADD
ON TIG UNIT
005002
/ 005011
Several makes
of TIG units are available. All are designed
to add on to any DC power source with an open
circuit voltage of 50 to 100 volts. Only limited
by the length of welding cable, these very
versatile units can be taken very close to
the job. All units are available with latch
facility.
Dimensions
Weight
Viper
335 x 230 x 200mm
11 Kgs
ISS
275 x 240 x 125mm 6.7 Kgs
VIPER
2000
005012
New to our
fleet is the Viper 2000. This unit is an in
line 'add on' TIG control unit, which will
operate from the OCV of any DC power source.
The unit controls arc initiation gas flow,
and has a torch switch latching facility.
Supply
Voltage Dimensions
Duty Cycle
Weight
40
- 100 volts DC
210 x 127 x 322mm
200 Amp @ 100%
5 Kgs
VIPER
2000S
005013
A sister to
the Viper 2000, the Viper 2000S is a new state
of the art HF unit, with digital display on
panel. It features slope up and down facilities
and will run off any DC power source. As above,
the unit will control arc initiation gas control
and features torch switch latching.
Supply
Voltage Dimensions
Duty Cycle
Weight
22
- 100 volts DC
300 x 190 x 450mm
200 Amp @ 100%
15 Kgs
MILLER
1A AND 2F TIG Units
005008
/ 005009
The Miller
1A and 2F add on TIG units both convert a
Miller Inverter into a Slope in/out TIG unit.
They are capable of working up to 30 metres
away by the addition of a control, welding
cables and Argon hose. The 2F has the added
benefit of a built in pulse unit. These units
can be water cooled with the addition of a
water tank.
